Advertising engraving machine spindle does not turn and debug data?

1. The main axis of the advertising engraving machine does not turn: We say that the main axis of the advertising engraving machine does not turn.

(1) The inverter power is too small;

(2) The motor insulation level does not meet the requirements;

(3) The output side is short-circuited and the motor cable is damaged;

(4) Accelerate overcurrent, acceleration time is too short;

(5) The V/F compensation value is too high;

(6) The V/F curve selection is not suitable;

(7) Motor problems;

(8) The load is too heavy;

(9) The error generation displayed on the LED display of the inverter.

(10) The voltage is unstable and exceeds the load range of the inverter.

(11) The spindle bearing of the engraving machine is damaged.

(12) The line is out of phase and short circuited.

2, advertising engraving machine debugging data:

(1) Check the tightness of the screws in each place after the machine is assembled.

(2) Check the tightness of the triaxial belt (just move at 90%)

(3) Check if the wiring of each part of the circuit is correct and whether the terminal is connected

(4) Check if the drag chain is dry

(5) After all the above are completed, the diagonal error will be adjusted (the large machine is around 0.3, and the small machine is around 0.1).

(6) Dimensional test Large machine uses a tape measure to measure the maximum number of strokes to walk (small machine direct engraving machine on the machine, the maximum stroke is good)

(7) Engrave a circle and a square of 150*150, 100*100, 50*50, 10*10 with a plate (accuracy is around 0.03)

(8) Open the vacuum test with vacuum so that the vacuum can be tested (the vacuum will know if the motor is good or bad and leaks if it is moved for 20 minutes)

(9) Finally, look at the paint of the appearance sheet metal

(10) After all the above completions, a continuous test (the program is a three-axis linkage) will take place after 4 hours of movement to see the spindle and the positioning point change. If there is a dry winding to check the static electricity. There is also the degree of heat of the motor